Cf_Dline Command; Cf_Setpcadj Command - Canon LV-7555 Specifications

8.5.7

CF_DLINE COMMAND

"CF_DLINE_%1"[CR]
COMMAND
"0100-nnnn"-- directly specify Display Line value
%1
"UP"---------------- Display Line +1
"DN"---------------- Display Line -1
Set Display Line of PC signal (Only valid when it is in the usual Power On
state.)
The value set by this Command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
Details setting. (stays in Stand By mode.)
(stays in Stand By mode.)
Note:When %1 is directly specified, this command is not enough to execute
for the screen.
COMMAND.
Acceptable
Response
Unacceptable
8.5.8

CF_SETPCADJ COMMAND

"CF_SETPCADJ" [CR]
COMMAND
N/A
%1 "EXT6"-"EXT60"
‚ P • D Execute the setting value in PC adjustment menu to show up on the
Details
‚ Q • D
Acceptable
Response
Unacceptable
"nnnn" means maximum.
To show up on the image, issue CF_SETPCADJ
"000"[CR]
"101"[CR] ---- When Input is Video Series
screen.
When %1 is directly set by PC CONTROL COMMAND as below and
SCREEN CONTROL SERIES COMMAND, the command will not be
executed. This command, "CF_SETPCADJ" is to execute the setting
value. (Only valid when it is in the normal Power On state.)
-CF_FSYNC
-CF_TDOTS
-CF_CLAMP
-CF_H-POS
-CF_V-POS
-CF_DLINE
-CF_DDOTS
-CF_FLSCREN
When %1 ‚ É "EXT6" - "EXT60" is set to %1, Content specified %1 by
EXT No.6 (not XGA No.1) will be displayed.
"000"[CR]
"101"[CR] ---- When Input is Video Series
This value is from current Total Line value – Vertical
Position value.
Page 23 / 53