Cf_Inputsearch Command; Cf_Autosetuppcadj Command; Cf_Autosetupkeystone Command; Cf_Autosetup Command - Canon LV-7290 Command Specifications

LV-7290 / LV-7295 / LV-7390/ LV-8225 Expand Serial Command Functional Specifications

8.10.3 CF_INPUTSEARCH Command

Command "CF_INPUTSEARCH_%1"[CR]
"OFF" ------------------------- Set Auto input operation to OFF
%1 "ON1" ------------------------- Set Auto input operation to On1
"ON2" ------------------------- Set Auto input operation to On2
Set Auto input operation mode.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
Details This command is available in normal Power ON status.
Note) It is unable to set Keystone, Auto PC and Auto input to OFF at once.
e.g. If projector receives Auto input OFF command while Auto PC and Keystone
are OFF, it returns error code "101"..
Acceptable
Response
Unacceptable

8.10.4 CF_AUTOSETUPPCADJ Command

Command "CF_AUTOSETUPPCADJ_%1"[CR]
"ON" ------------------- Set Auto PC function to ON
%1
"OFF" ------------------ Set Auto PC function to OFF
Set/Cancel Auto PC function
This command is available in normal Power ON status.
Details Note) It is unable to set Keystone, Auto PC and Auto input to OFF at once.
e.g. If projector receives Auto PC OFF command while Keystone and Auto input
are OFF, it returns error code "101".
Acceptable
Response
Unacceptable

8.10.5 CF_AUTOSETUPKEYSTONE Command

Command "CF_AUTOSETUPKEYSTONE_%1"[CR]
"AUTO" ------------------- Set Auto Keystone function to Auto
%1 "MANUAL" --------------- Set Auto Keystone function to Manual
"OFF" --------------------- Set Auto Keystone function to OFF
Set Keystone function of Auto setup
This command is available in normal Power ON status.
Details Note) It is unable to set Keystone, Auto PC and Auto input to OFF at once.
e.g. If projector receives Keystone OFF command while Auto PC and Auto input
are OFF, it returns error code "101"..
Acceptable
Response
Unacceptable

8.10.6 CF_AUTOSETUP Command

Command "CF_AUTOSETUP_%1"[CR]
%1 "START" ------------------- Execute Auto Setup
Execute Auto Setup
Details Note) CF commands does not execute while Auto setup is in process. If the
command is sent during this, projector returns error code "302"
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
38