Sensata Dimensions 12LPC15 Owner's Manual page 16

BTS Connection Continued
Install the BTS
1. Connect the lug end of the battery temperature sensor to the battery.
NOTE: Lead-acid battery type will connect the BTS to the negative post of the battery. LFP battery types will
connect the BTS to the positive post of the battery.
2. Connect the connector to the appropriate port located at the rear of the inverter labeled "Temp Sense." The
BTS is part# ME- BTS-XX (XX=length in feet - 6, 8, 15, 25, 40). The 40 ft version comes standard with the
inverter/charger (unless a non-charger version is ordered).
NOTE: The BTS must be connected prior to running the charger, otherwise it will read an incorrect
battery temperature. If the BTS is not connected, the battery charger will not function.
Page 16
Figure 8 Battery Temperature Sensor
12LPC15 Manual