Front Panel Functions - XIEGU X5105 Operation Manual

1 [Power]
HOLD to turn the radio ON or OFF.
When radio is OFF, TAP to display charging voltage and battery voltage.
To force a reset of the MCU, press and hold [Power] for 10 seconds.
NOTE: Always use [Power] to turn the X5105 on or off. This will ensure that the transceiver configuration
is saved. NEVER switch off by removing an external power supply.
2 [MODE]
TAP to select next operating mode in sequence:
HOLD [MODE] to toggle between Split ON and Split OFF. In Split operation VFOA is used for receiving, VFOB
is used for transmitting. When in Split operation, the split icon is visible beside the VFOB frequency.
3 [PRE/ATT]
TAP to engage the RF preamplifier, attenuator, or neither in sequence: PREAMP-ATTENUATOR-OFF
4 [RIT]
TAP to toggle RIT function ON or OFF.
When ON, set Rx offset (±1.5 kHz) by rotating [KNOB]
HOLD RIT to zero the RIT setting.
Xiegu X5105 Operating Manual 5

Front Panel Functions