Pulling Up The Bobbin Thread - Brother Computerized Embroidery Sewing Machine Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
m Press
The initial screen appears again, and
appears.
CAUTION
● When using the twin needle, be sure to
select the twin needle setting, otherwise
the needle may break or the machine may
be damaged.
n Start sewing.
• For details on starting to sew, refer to
"Starting to sew" (page 47).
Two lines of stitching are sewn parallel to
each other.
Note
When changing the sewing direction, press
(Needle position button) to raise the
needle from the fabric, and then raise the
presser foot lever and turn the fabric.
CAUTION
● Do not try turning the fabric with the
twin needle left down in the fabric,
otherwise the needle may break or the
machine may be damaged.
● When the twin needle mode is selected
( ), do not turn the balance wheel
after removing the thread cassette.
Otherwise the needle may break or the
machine may be damaged.
(Back key).

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
a Insert the bobbin into the shuttle.
a
• Refer to steps through
bobbin" (page 19).
b Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
c While lightly holding the upper thread with
your left hand, press
button) twice to raise the needle.
1
a Needle position button
The bobbin thread is looped around the
upper thread and can be pulled up.
d Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
e
of "Installing the
(Needle position
Upper Threading 31
1