Darning - Brother Computerized Embroidery Sewing Machine Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES

Darning

Fabric that has been torn can be darned.
Darning is sewn as shown below.
a Reinforcement stitching
Determine the desired length of the darning.
a
Set the button guide plate on buttonhole foot
"A" to the desired length. (The distance between
the markings on the presser foot scale is 5 mm
(3/16 inch).)
2
4
a Presser foot scale
b Length of darning
c 5 mm (3/16 inch)
d 7 mm (1/4 inch)
• A bar tack with a maximum length of about
28 mm (1-1/8 inch) can be sewn.
Attach buttonhole foot "A".
b
• For details, refer to "Replacing the presser
foot" (page 38).
100
1
3
1
52
Select stitch or
c
• For details, refer to "Selecting stitching" (page
45).
d Position the fabric so that the needle is 2 mm
(1/16 inch) in front of the area to be darned,
and then lower the presser foot lever.
1
a Tear
b 2 mm (1/16 inch)
Pass the upper thread down through the hole in
the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
darning will not be sewn with the correct
size.
1
53
.
2