Canon PIXMA MX700 Series Quick Start Manual page 88

(2) Press on the
the ink tank snaps firmly into place.
(3) Make sure that the ink lamp lights up red.
Important
The machine cannot be used unless all the ink tanks
are installed.
6
Lift the Scanning Unit (Printer Cover) slightly to set the Scanning Unit Support back
to its original position, and then gently close the Scanning Unit (Printer Cover).
Caution
Be sure to hold the Scanning Unit (Printer Cover) firmly using both hands, and be careful not to
get your fingers caught.
Do not hold the LCD.
Note
If the error message is still displayed after the Scanning Unit (Printer Cover) is closed, see "An
Error Message Is Displayed on the LCD" on page 101.
When you start printing after replacing the ink tank, Print Head Cleaning is performed
automatically. Do not perform any other operations until Print Head Cleaning finishes.
Note
If you have pressed the Stop/Reset button for at least 5 seconds when "The remaining level of the
ink cannot be correctly detected." or "The ink has run out. Replace the ink tank." appears on the
LCD, note the following.
When ink runs out, printouts will become faint or blank printouts will be printed.
When receiving faxes, the machine will not store it in its memory even if the ink level becomes low
or run out.
84 Routine Maintenance
mark on the ink tank until
(3) (2)