Canon PIXMA MX700 Series Quick Start Manual page 71

Note
Set your answering machine to answering mode and adjust it as follows:
– The entire message should be no longer than 15 seconds.
– In the message, tell your callers how to send a fax.
The machine can be set to receive faxes automatically after the telephone rings for a specified
length of time. Set Manual/auto switch in RX settings under FAX settings to ON, and then
specify the automatic reception start time. Refer to "Manual/auto switch" in "Device Settings" of
the User's Guide on-screen manual.
If you have subscribed to Duplex Ringing service in Hong Kong, the machine will receive faxes
automatically even if you set the receiving mode of the machine to TEL priority mode.
If You Are Using a Single Telephone Line for Faxes and Voice Calls and
Want to Receive Faxes Automatically:
Select FAX priority mode.
(A)
(A) Incoming call
(B) Voice call: The machine will ring. Pick up the handset, then press the Stop/Reset button to
answer the call.
Important
When answering a voice call, be sure to pick up the handset before pressing the Stop/Reset
button. If you press the Stop/Reset button before picking up the handset, the telephone call will be
disconnected.
(C) Fax: The machine receives faxes automatically.
Note
The following settings can be modified to control how your machine handles incoming calls.
Specify the FAX priority mode settings in RX settings under FAX settings. Refer to "FAX priority
mode" in "Device Settings" of the User's Guide on-screen manual.
The time the machine takes to determine whether a call is a fax or a voice call
The time the machine rings when the call was a voice call
Whether or not the machine receives the fax after the specified ring time has elapsed
(B)
(C)
Faxing 67