Reinstalling The Multipass Suite; Changing The Port Connection - Canon MultiPASS F60 Software User's Manual

If your installation of the MultiPASS Suite becomes damaged at some
point (for example, program files are accidentally deleted from the
system), you can repair your installation without having to remove and
reinstall the software. To do so, follow the instructions for removing the
MultiPASS Suite. However, when prompted, click Repair instead of
Remove. Then, follow the on-screen instructions. You may need to have
your MultiPASS Suite installation disk available during the repair
process.
If you are still unable to install using the method above, carry out the
operation in Chapter 8, "Installation stops before it is completed".

Reinstalling the MultiPASS Suite

After you have uninstalled the MultiPASS Suite, you use the same
instructions for reinstalling as described in Chapter 2, "Installing the
MultiPASS Suite."

Changing the Port Connection

To change ports between USB ports, or a USB port with a hub:
Simply disconnect the USB cable from the USB port on your computer
and, when ready, reconnect to the other USB port or hub.
When changing the port connection, it is not necessary to remove and
reinstall the MultiPASS Suite software.
Chapter 7 Fine-tuning the MultiPASS Suite 163
6
6