Replacing The Light Bulbs - decorflame M405-48FBK Manual

REPLACING THE LIGHT BULBS

Step 1: Remove 12 screws on the back of fireplace and open the rear cover. There are 2
larger screws and 10 smaller screws.
Step 2: You will find 1 x 40W type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into top left corner hole and bottom
right corner holes, as shown in the diagram. Secure the 10 smaller screws into
the remaining holes. Make sure the screws are in the correct holes and have been
tightened.
Step 5: Plug in the unit.
Larger screw
REPAIR SET
TOUCH-UP REPAIR PAINT
Paint directly on the mantel unit if necessary.
Larger screw
Bulb
REPAIRS
If any problems are found with the original parts during mantel assembly such as the
panels cannot be installed with the plastic connector. Try to solve by one of the following
methods.
Tools required: electric drill, drill bits 10 mm (3/4 in) or 2 mm (1/16 in), pencil, hammer,
Phillips screwdriver, safety goggles and gloves (if necessary).
warNiNG: wEar GOGGlES BEFOrE yOU Start DrilliNG.
OptiON 1:
Use the spare nuts, screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes, as shown in
Fig. A.
2. Drill the holes with diameter 10 mm (3/4 in) and depth 10 mm (3/4 in) on the mantel.
Each plastic connector needs 3 holes. See Fig.B.
Fig. B
3. Gently install the nuts into the drilled-holes with hammer, as shown in Fig. C.
4. Attach the plastic connector and lock in place with screws, as shown in Fig. D.
6
Fig. A
Fig. C
Fig. D Back