Table of Contents
Advertisement
Care and Maintenance
i
Use the cleaning brush or a vacuum cleaner to remove
any lint and dust from the race and bobbin thread
sensor and the surrounding area.
c
1 Cleaning brush
2 Race
3 Bobbin thread sensor
Note
• Do not apply oil to the
Insert the bobbin case so that the mark on the
j
bobbin case aligns with the
a
b
• Align the and
marks.
1 mark
2
mark
3 Bobbin case
• Make sure that the indicated points are aligned
before installing the bobbin case.
k
Insert the tabs on the needle plate cover into the
needle plate, and then slide the cover back on.
Reattach the bobbin cover.
CAUTION
• Never use a bobbin case that is scratched or
has a burr on it. Otherwise the upper thread
may become tangled, the needle may break or
stitching performance may suffer. For a new
bobbin case, contact your nearest authorized
Baby Lock retailer.
• Be sure that the bobbin case is correctly
installed, otherwise the needle may break.
52
a
.
bobbin case
mark on the machine.
a
b
c
Touch panel is malfunctioning
If the screen does not respond correctly when you touch a key
(the machine does not perform the operation or performs a
different operation), follow the steps below to make the
proper adjustments.
a
Holding your finger on the screen, turn the main
power switch to OFF and back to ON.
The touch panel adjustment screen is displayed.
Lightly touch the center of each +, in order from 1 to 5.
b
+1
+2
c
Turn the main power to OFF, then turn it back to ON.
Replacing the embroidery foot
CAUTION
• Only use embroidery feet designed specifically
for this machine. Use of any other embroidery
foot may result in injuries or damage to the
machine.
a
Press
(Needle position button) once or twice to
raise the needle.
b
Press
.
• When the message [OK to automatically lower the
presser foot?] appears on the LCD screen, press
to continue.
The screen changes, and all keys and operation
buttons are locked (except
c
Raise the presser foot lever.
+4
+5
+3
).
Advertisement
Table of Contents
