Table of Contents
Advertisement
1
Chapter
Note
• Be sure to install the latest software.
Refer to "Updating Your Machine's Software" on
page 59.
Names of Machine Parts
■ Main parts
c
a b
m
l
k
n
t
s
q
r
1 Top cover
(page 18)
2 Thread guide plate (page 19)
3 Thread guide cover
4 Bobbin winding thread guide and pretension disk
(page 20)
5 Spool cap (page 19)
6 Spool pin (page 19)
7 Bobbin winder (page 18)
8 LCD (liquid crystal display) (page 14)
9 Operation panel (page 10)
0 Operation buttons (page 10)
A Embroidery unit
B Thread cutter (page 24)
GETTING READY
e f
d
g
h
j
p
C Needle threader lever (page 24)
D Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle.
E Handle
Carry the machine by its handle when transporting.
F Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot.
G Main power switch (page 13)
H Power supply jack (page 13)
I Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
J USB port (for a USB flash drive) (page 49)
■ Needle and presser foot section
i
f
e
1 Needle bar thread guide (page 23)
2 Needle plate
3 Needle plate cover (page 21)
4 Bobbin cover/bobbin case (page 21, 51)
5 Embroidery foot (page 36, 52)
The embroidery foot helps control fabric flexibility for better
stitch consistency.
6 Embroidery foot screw (page 53)
Use the embroidery foot screw to hold the embroidery foot in
place.
Names of Machine Parts
c
9
1
Advertisement
Table of Contents
