Table of Contents
Advertisement
2
Chapter
Embroidering Preparation
Follow the steps below to prepare the machine for
embroidery.
Step 2
Step 1
Step 4 Step 5
Step
Aim
#
1
Checking the
Use needle for embroidery.
needle
2
Embroidery unit
Attach the embroidery unit.
attachment
3
Bobbin thread
For the bobbin thread, wind
setup
embroidery bobbin thread and
set it in place.
4
Fabric
Attach a stabilizer material to
preparation
the fabric, and hoop it in the
embroidery frame.
5
Embroidery
Attach the embroidery frame
frame
to the embroidery unit.
attachment
6
Pattern selection Select an embroidery pattern.
7
Checking the
Check and adjust the size and
layout
position of the embroidery.
8
Embroidery
Set up embroidery thread
thread setup
according to the pattern.
EMBROIDERY
Step 8
Step 6, 7
Step 3
Action
Page
25
27
18
29
31
33
35
36
Attaching the embroidery unit
CAUTION
• Before attaching the embroidery unit, be sure
to turn off the machine. Otherwise, injuries
may occur if one of the operation buttons is
accidentally pressed and the machine starts
embroidering.
• Do not move the machine with the embroidery
unit in place. The embroidery unit may be
dropped and cause injury.
• Keep your hands and other objects away from
the embroidery carriage and frame when they
are moving. Otherwise injury may result.
Turn off the machine.
a
Slide the tab on the cover of the connection port in the
b
direction of the arrow to open the cover.
Note
• Be sure to close the cover of the connection port
when the embroidery unit is not being used.
c
Insert the embroidery unit connection into the
connection port, and then lightly push in the
embroidery unit until it snaps into place.
3
1 Connection port
2 Embroidery unit connection
3 Carriage
Embroidering Preparation
1
2
27
2
Advertisement
Table of Contents
