Table of Contents
Advertisement
Using the Thread Trimming Function (Jump
Stitch Trim)
The thread trimming function
excess thread jumps within the color. Embroidery frame
(small) cannot be used. This function is initially turned on. To
turn this function off, press
* Your customized setting remains after turning the machine
off and on.
CAUTION
• The carriage of the embroidery unit will move.
Keep your hands etc. away from the carriage.
Otherwise injury may result.
Note
• When this function is turned on, use a ball point
needle 75/11 for embroidering patterns (sold
separately) with short jump stitches such as
alphabet characters. Using other needles may
cause the thread to break.
■ Selecting the Length of Jump Stitch Not to Trim
When the thread trimming function
can select the length at which jump stitch trimming starts.
* Your customized setting remains after turning the
machine off and on.
Press
or
to select the length of jump stitch.
For example: Press
to select 25 mm (1 inch) and the
machine will not trim a jump stitch of 25 mm or less
before moving to the next stitching.
Memo
• If a design has many trims it is recommended to
select a higher jump stitch trim setting in order to
reduce the amount of excess tails on backside of
fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the machine
will trim. In this case, more jump stitches will
remain on the surface of the fabric.
will automatically trim any
key and then
.
1 Jump stitch
is turned on, you
Embroidering the appliqué patterns
When the color embroidering order display shows
[
(APPLIQUE MATERIAL)],
[
(APPLIQUE POSITION)] or
[
(APPLIQUE)], follow the procedure below.
Required materials
• Fabric for the appliqué piece
• Fabric for the appliqué base
• Stabilizer material
• Fabric glue or temporary spray adhesive
• Embroidering thread
Note
• The correct names and numbers of the thread
colors to be used will not appear. Select the thread
colors depending on those in the appliqué pattern.
■ 1. Creating an appliqué piece
Attach stabilizer material to the wrong side of the
a
appliqué fabric.
b
Sew the cutting line of the appliqué piece. Remove the
fabric for the appliqué piece from the embroidery
frame, and then carefully cut along the sewn cutting
line.
1 Outline of appliqué
2 Appliqué material
Note
• If the appliqué piece is cut out along the inside of
the cutting line, it may not be correctly attached to
the fabric. Therefore, carefully cut out the appliqué
piece along the cutting line.
• After cutting out the appliqué piece, carefully
remove any remaining thread.
Embroidering
2
41
Advertisement
Table of Contents
