Table of Contents
Advertisement
Embroidering Preparation
Note
• Make sure that there is no gap between the
embroidery unit and the machine, otherwise the
embroidery pattern may not be embroidered
correctly. Be sure to fully insert the connector into
the connection port.
• Do not push on the carriage when attaching the
embroidery unit to the machine, otherwise damage
to the embroidery unit may result.
• Do not touch the connector in the embroidery unit
connection slot. The connector could be damaged,
and it may cause malfunctions.
• Do not lift up on the embroidery carriage, and do
not forcefully move it. It may cause malfunctions.
d
Turn on the machine.
A message appears in the screen.
Note
• If [Opening Screen] is set [ON] within the settings
screen, touch screen for the following message to
appear.
e
Be sure that no objects or hands are near the
embroidery unit and press
The carriage moves to its initial position.
The screen for selecting the embroidery pattern type
is displayed.
■ Removing the embroidery unit
Make sure that the machine is completely stopped and
follow the instructions below.
a
Remove the embroidery frame.
• For details on removing the embroidery frame, refer
to "Removing the embroidery frame" on page 32.
b
Press
, and then press
The embroidery carriage moves into a position
where it can be stored.
28
.
.
c
Turn off the machine.
CAUTION
• Always turn off the machine before removing
the embroidery unit.
It may cause malfunctions if removed when
the machine is turned on.
Hold the release button on the bottom left of the
d
embroidery unit, and slowly pull the embroidery unit
to the left.
Advertisement
Table of Contents
