Troubleshooting Guide - Canon EOS 1D Instructions Manual

Troubleshooting Guide

If there is a problem, first refer to this Troubleshooting Guide.
Power Source
The battery You are using the wrong battery.
s
cannot be
recharged.
The battery is not properly attached to the charger.
s
The battery is exhausted.
The camera does
s
not operate even
when the < >
The battery is not installed properly.
switch is set to
s
< >.
The CF card slot cover is open.
s
If you set the <
The access lamp
still blinks even access lamp will still blink for a few seconds while the image is recorded
when the < > onto the CF card.
s
switch is set to
< >.
The battery The battery is not fully charged.
s
becomes
exhausted
The battery's service life has expired.
quickly.
s
The camera turns Auto power off is in effect.
s
off by itself.
Only the < > The battery has almost exhausted.
s
icon is displayed on
the top LCD panel.
162
Use the dedicated Ni-MH Pack. (→p.22)
Attach the battery properly to the charger. (→p.22)
Recharge the battery. (→p.22)
Install the battery properly. (→p.23)
Push in the CF card until the CF card release button pops up. Then
close the CF card slot cover. (→p.27)
> switch to <
When the camera finishes recording the image to the CF card, the
access lamp will stop blinking and the power will turn off.
Recharge the battery fully. (→p.22)
Replace the battery with a new one. (→p.166)
Set the < > switch to <
(→p.130)
Recharge the battery. (→p.22)
> right after taking a picture, the
> again or set auto power off to "Off."