Table of Contents
Advertisement
Reference
Troubleshooting Guide
If there is a problem, try to resolve it by referring to this Troubleshooting
Guide. If the problem still persists, take the camera to your nearest Canon
Service Center.
Nothing is
displayed on the
LCD panel.
The batteries are exhausted.
• Replace the batteries with new ones. (-tpage 18, 19)
The batteries have been installed incorrectly.
► Install the batteries correctly. (-tpage 18)
The picture looks
blurred.
The lens focus mode is set to <MF> (or <M>).
► Set the lens focus mode to
<AF>
(or
<A>).
(->page 20)
There was camera shake when the picture was taken.
► Hold the camera steady or use a faster shutter speed.
(-tpage 22)
The shutter does
not work.
The < @ > icon blinks on the LCD panel.
• Take out the film and load it correctly. (->page 23)
The < 0 > icon blinks on the LCD panel.
* Replace the batteries with new ones, (-tpage 18)
The <@> icon blinks while the rewound film is still in the
camera.
« Replace with a new roll of film. (->page 23)
The in-focus indicator in the viewfinder blinks and locus
cannot be achieved.
► Select another focusing point, (-tpage 45) If focus still
cannot be achieved, focus manually, (-tpage 48)
The < Q > icon
blinks on the LCD
panel.
The battery level is very low.
• Replace the batteries with new ones, (-tpage 18)
A misoperation has occurred.
• Press the shutter button halfway, (-tpage 22)
• Remove and reload the batteries, (-tpage 19) If the < 0 >
icon stops blinking, picture-taking is possible.
If it is still blinking, consult your nearest Canon Service
Center.
96
Advertisement
Table of Contents
