Recharging the Battery
First, recharge the battery.
•
For details on the battery, refer to the instructions for the Ni-MH Pack NP-E3.
•
For details on how to recharge and discharge the battery, refer to the instructions for the
Ni-MH Charger NC-E2.
22
Connect the power cord.
1
•
Connect the power cord to the charger.
•
Connect the power plug to an AC outlet.
s
The < POWER > lamp will light.
Detach the protective cover.
2
•
Attach the cover to the battery compartment cap
and retain it.
•
Whenever the battery is out of the camera, be sure
to attach the protective cover to prevent short
circuit.
Connect the battery.
3
•
Connect the charging plug to the battery's charging
terminal.
•
The charging plug can be connected to either
terminal A or B.
Battery recharging starts.
4
s
When the battery is connected, recharging starts
automatically and the <
s
When the battery is completely recharged, the lamp
will start blinking (twice per second).
s
A completely exhausted battery takes about 2
hours to fully recharge.
•
After recharging the battery, disconnect it and
unplug the power cord from the AC outlet.
> lamp lights.