8
Commissioning
Incorrectly mounted manifold/module!
A powerful fluid jet may leak at incompletely mounted hydraulic connections and
connection lines and cause serious injuries.
▶
Only commission your system after all hydraulic connections and the manifold
and/or the module have been completely and properly mounted according to
the specifications.
▶
Look out for defective sealing points and exchange defective seal rings
immediately.
▶
Wear personal protective equipment during the initial commissioning.
Inadmissibly high operating pressure!
Thus, the manifolds and/or the modules may burst or the closing elements may fly
around and cause serious injuries.
▶
Before commissioning the hydraulic system, ensure that the maximum admis-
sible pressure of the hydraulic components in the system is not exceeded by
no means.
▶
Ensure that in your system, the maximum admissible operating pressure is se-
cured by means of pressure limitation equipment.
Uncontrolled connection or disconnection of plug-in connectors!
Electric components may be damaged.
▶
Before installation works, separate the device from the mains or from the
voltage source or de-energize it.
▶
Do not plug in or pull the electric plug-in connector as long as the voltage supply
is activated.
▶
Make sure that all hydraulic connections are covered and all electrical connec-
tions are allocated.
▶
Immediately depressurize the system if hydraulic fluid still leaks despite prop-
er assembly.
▶
Commission hydraulic components only if they are completely installed.
▶
Allow manifolds/modules with integrated electronics to acclimatize for some time
prior to commissioning as the electronics might be damaged by the generation of
condensed water.
▶
Electrical connections must be checked for proper condition by or under the
guidance and supervision of a specialized electrician before the initial or any
re-commissioning.
▶
Check before switch-on whether the protective earthing conductor at all electric
devices is firmly connected according to the connection diagram.
wARnInG
NOTICE
RE 07601-B/12.2013, manifolds and modules, Bosch Rexroth AG
Commissioning
23/36