Takeuchi TB215R Workshop Manual page 207

3. Fit the O-ring to the seal ring and then attach them to
the housing.
• Align the seal ring pin with the pin hole on the
housing.
Apply grease to the O-ring.
4. Attach the housing, and insert the hydraulic motor.
• Tighten the housing and the hydraulic motor
flanges with a C clamp or a hydraulic press.
5. Insert the steel balls (19) with retainers of the bearing
and the inner race (18) into the flange holder.
6. Insert the snap ring.
TRAVEL MOTOR
DISASSEMBLY AND ASSEMBLY
11
4
TRAVEL MOTOR
4M0AX00