Table of Contents
Advertisement
CAUTION:
1. Always turn the system power off before installing or removing
any device.
2. Always observe static electricity precautions. See "Handling Pre-
cautions" at the start of this manual.
3. Inserting the chip incorrectly may damage the chip.
To install the CPU, do the following:
1.
Lift the lever on the side of the CPU socket.
2.
Handle the chip by its edges and try not to touch any of the pins.
3.
Place the CPU in the socket. The chip has a notch to correctly locate the
chip. Align the notch with pin one of the socket. Pin one is located in the
blank triangular area. Do not force the chip. The CPU should slide easily
into the socket.
4.
Swing the lever to the down position to lock the CPU in place.
5. See the following sections for information on the CPU jumpers settings.
4). Install Expansion Cards
This section describes how to connect an expansion card to one of your
system's expansion slots. Expansion cards are printed circuit boards that,
when connected to the mainboard, increase the capabilities of your system.
For example, expansion cards can provide video and sound capabilities. The
mainboard features
slots.
one 16-bit ISA bus and three 32-bit PCI bus
Installation Procedures
expansion
2 - 13
Advertisement
Table of Contents
