LifeSize Bridge 2200 Administrator's Manual page 24

System Reboot
The system reboots when you do any of the following:
•
Manually reboot the system (Diagnostics : System Reboot).
•
Reset the system to its default state (Maintenance : System Reset).
•
Revert the system to the previous state (Maintenance : System Revert).
•
Restore the system to a saved state (Maintenance : System Restore).
•
Change the VLAN ID preference (Preferences : Network : VLAN ID).
•
Change TCP reserved ports (Preferences : Network : Reserved Ports).
•
Change the UDP signaling port, enable or disable TCP or TLS signaling, or change the TCP or TLS
signaling ports.
•
Upgrade the system software (Maintenance : System Upgrade).
•
Change IP address.
•
Change protocol and network preferences; these are disabled if calls are in progress. Schedule a
maintenance window to make these changes by creating a conference that uses all ports and has a
password that is not shared.
You may need to reboot a system that fails to connect calls. To reboot the system, click
Diagnostics : System Reboot.
If calls are in progress, you are prompted to continue or cancel. Press Continue to disconnect the calls
and complete the reboot.
NOTE
If the user interface is not responding and you are unable to reboot the
system, press the reset button on the front of the system. LifeSize
recommends you do not unplug power from the system to reboot it.
LifeSize Bridge 2200 Administrator Guide
in
24