MRC CCM-10 Instruction Manual

MRC CCM-10 Instruction Manual

Table cut mill

Advertisement

INSTRUCTION MANUAL FOR
Table Cut Mill
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529
mrc@mrclab.com
MRC.VER.01-07.10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CCM-10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MRC CCM-10

  • Page 1 INSTRUCTION MANUAL FOR Table Cut Mill PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION 3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529 mrc@mrclab.com MRC.VER.01-07.10...
  • Page 2 Ⅰ、 OUTLINE 【1】 Wind outlet 【7】 Current meter 【2】 Pulverized material 【8】 Power switch outlet 【3】 Shaft base (for holding 【9】 No Fuse Breaker (NFB) the shaft 【4】 Loading tube 【10】 Wind power adjuster 【5】 Loading trough 【11】 Pulverizing trough 【6】...
  • Page 3 Ⅱ、 OPERATION 1. At first, please make sure whether the wind outlet (【1】) & pulverized material outlet (【2】) have been covered with the cloth pipes. The cloth pipe for covering (【1】) is shorter and there’s a loop for hanging on the shaft. The cloth pipe for covering (【2】) is longer.
  • Page 4 、 CAUTION 1. When NFB is cut off, please turn off the power switch for 10 minutes and press NFB again to restart. The following situations would be the possible reasons to cause a NFB to be cut off. 1) The speed of material loading is too fast. It’s necessary to discharge the material more or less before re-starting.

Table of Contents