Table of Contents
Advertisement
Certification
6.1.2 CSANe
•
•
The device is marked with a CSA symbol that indicates compliance with both
Canadian and U.S. requirements.
C
It is specifically approved for use in Division 2 and Zone 2 hazardous locations with
the following markings:
•
•
•
This device meets the requirements of the following International standards under
certificate IECEx CSA 21.0001X:
•
•
•
6.1.2
CSANe
When marked with the following ATEX marking, this device is approved for use in
Zone 2 hazardous locations under certificate CSANe 21ATEX3001X.
Note
For the maximum ambient temperature, refer to the hazardous location label affixed
to the device.
Ex ec nC IIC T4 Gc
The device also meets the requirements of the following European directive and
standards:
34
ANSI/UL 60079-15:20
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Type of Protection
"n"
ANSI/UL 60079-7:2017
Explosive atmospheres – Part 7: Equipment protection by increased safety ''e''
US
Class I, Division 2, Groups A, B, C, D T4
Ex ec nC IIC T4 Gc
Class I, Zone 2, AEx ec nC IIC T4 Gc
IEC 60079-0:2018
Explosive Atmospheres – Part 0: Equipment – General Requirements
IEC 60079-15:2017
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Construction, Test
and Marking of Type of Protection "n" Electrical Apparatus.
IEC 60079-7:2017, Edition 5.1
Explosive atmospheres – Part 7: Equipment protection by increased safety "e"
II 3 G
RUGGEDCOM RST916P
Installation Manual, 04/2021, C79000-G8976-1489-01
Advertisement
Table of Contents
