Connections; Recording Outgoing Message (Ogm) On An External Tad - Brother MFC MFC-5440CN User Manual

Connections

The external TAD must be connected as shown above.
1
Set your external TAD to one or two rings. (The MFC's Ring
Delay setting does not apply.)
2
Record the outgoing message on your external TAD.
3
Set the TAD to answer calls.
4
Set the Receive Mode to External TAD .
(See Choosing the Receive Mode on page 4-1.)

Recording outgoing message (OGM) on an external TAD

Timing is important in recording this message. The message sets up
the ways to handle both manual and automatic fax reception.
1
Record 5 seconds of silence at the beginning of your message.
(This allows your MFC time to listen for the fax CNG tones of
automatic transmissions before they stop.)
2
Limit your speaking to 20 seconds.
We recommend beginning your OGM with an initial 5-second
silence because the MFC cannot hear fax tones over a resonant
or loud voice. You may try omitting this pause, but if your MFC has
trouble receiving, then you must re-record the OGM to include it.
A - 7 APPENDIX A