Spectra Logic T950 Instructions Manual page 9

Replace the VAX Bumpers
Lubricate the Linear Rail
1. Using a lint-free cleaning wipe, remove any debris or old grease from
2. Use a foam applicator to apply four thin, evenly spaced, 1-inch long
Figure 9 Apply four, 1-inch strips of VAX grease in the bearing groove along each side of the VAX
linear rail.
June 2013
the entire length of the VAX rail, especially in the bearing grooves on
the sides of the rail.
Figure 8 Clean the linear rail, including the bearing grooves.
strips of VAX grease (white, PN 90948215) in the bearing groove along
each side of the VAX linear rail.
 You can use any non-shedding, non-scratching applicator to
Notes:
apply the grease.
 Do not apply an excessive amount of grease.
VAX linear rail
~1 inch of grease applied
to VAX linear rail
Bearing groove
VAX Bumper Replacement—Spectra T950 Library
Lubricate the Linear Rail
Bearing grooves
9