Spectra Logic T950 Instructions Manual page 10

Library

Hide thumbs Also See for T950:

Replace the VAX Bumpers

3. Apply a thin layer of VAX grease to the flat surface of the linear rail to

4. While supporting the transporter from the bottom, remove the binder

5. Use a lint-free cleaning cloth to wipe away any excess grease that

June 2013

prevent potential oxidation.

Flat surface of the

linear rail

Figure 10 Apply a thin layer of VAX grease to the new linear rail.

clip and slowly move the transporter from the middle to the top of the

VAX linear rail and then allow the transporter to slide down to its

resting position.

As the transporter moves along the linear rail, the bearing mounts

distribute the grease along the rail.

Note:

As you move the transporter, listen for any abnormal sounds (for

example, metal-on-metal grinding or screeching). Contact

Spectra Logic Technical Support if you hear any any abnormal

sounds (see

Contacting Spectra Logic on page

collects at the top and bottom ends of the VAX linear rail.

Do not use alcohol on the wipe.

Note:

Figure 11 Excess grease pushed to the end of the VAX linear rail.

VAX Bumper Replacement—Spectra T950 Library

Lubricate the Linear Rail

2).

VAX linear rail

Remove

excess grease

Table of Contents