Section 1; Setting Up The Unit; Choose A Location; Power Supply - Digital Check SmartSource SSM1-MICROELITE-SEIJ Installation And Operation Manual

Installation & Operations Guide - SmartSource Micro Elite IJ

Section 1

Setting up the Unit

Choose a Location

➢ The unit is for indoor use only
➢ The location should be clean, dry, well-ventilated and out of direct sunlight
➢ Select a flat, stable location
➢ A suitable USB port on the host PC must be within 10 feet (3 meters) of the rear of the unit
➢ A suitable AC outlet (100-240 VAC, 50/60 Hz) must be with 6.5 feet (2 meters) of the rear of the unit
➢ Provide adequate clearance on all four sides of the unit to load/unload documents, insert rigid cards, open covers
for cleaning, and make power and USB connections

Power Supply

Your SmartSource Micro Elite IJ unit may be affected by surges or dips in the electrical power supply. These may cause
the unit to pause, or stop working, or require the user to restart the unit. Such surges and dips will generally not harm the
unit.
Surge and dips are usually the result of other large electrical loads on the same branch circuit, such as air-conditioners or
heaters.
If such problems occur, try connecting the unit to a different branch circuit outlet that does not supply other large electrical
loads. If problems persist, it may be necessary to isolate the unit from the power supply outlet using a line conditioning
device or an Uninterruptible Power Supply (UPS), both of which are available from Digital Check.

Need Help?

➢ In the USA, you can call the Digital Check Help Desk at 1-847-446-2285
➢ For help outside the USA contact your authorized service provider.
➢ Online, go to
www.digitalcheck.com
training/support videos.
➢ For replacement, service and support parts, visit
Rev. 022720
for general product information, manuals, drivers and downloads and
www.digitalcheck.com
8227 5727-003 Page 6 of 27