Hydraulic Settings - Leibinger JET Rapid Operating Manual

4.3

Hydraulic settings

Approved and not approved ink
The following examples shows the differences between an approved- and an not approved
ink:
In the mainscreen switch in the menu „Settings" and click on the option
-
<HydraulicSettings>
Ink approved
In this example the ink 70000-00134 is selected and also approved for all printers of
the High Speed Line, except the Wire (PI)
 Take over the settings by click on the button <Yes>.
Ink not approved
Release R.1.02

X
The appropriate default values for:
Max. Frequency (KHz)
-
Pressure (mbar) and
-
Fall Time (msec)
-
appears in the right area.
This ink can use without any problems.
In this example the ink 70000-00105 is
selected but not approved for the
printers of the High Speed Line:
No default values
appears!
Page 23
High Speed Line