Displays2go PROMXMN Series Assembly Instructions

Promotional counters

ASSEMBLY INSTRUCTIONS

PROMXMN Series - Promotional Counters

Remove the parts from the included carrying bag. The kit should include the folded plastic frame, wooden

countertop, two plastic shelves, two aluminum poles and plastic header.

STEP 1. Unfold the plastic frame and positioning it so the sides are at 90 degree angles to the front. Make sure that

metal shelf supports are placed on the inside and the small metal feet are at the bottom.

STEP 2. Attach the two shelves to the inside of the display. Hooks on the shelves connect to the support rails as

shown below.

STEP 3. After shelves are installed, rest the wooden countertop on top of the plastic frame. There are holes in the

countertop to accommodate the two included poles. Insert each pole into the two holes in the countertop.

Be sure that the Velcro® patches on the poles face front to hold the header.

- 1 -

V19.12

Table of Contents

Need help?

Do you have a question about the PROMXMN Series and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS PROMXMN Series - Promotional Counters V19.12 Remove the parts from the included carrying bag. The kit should include the folded plastic frame, wooden countertop, two plastic shelves, two aluminum poles and plastic header. STEP 1. Unfold the plastic frame and positioning it so the sides are at 90 degree angles to the front. Make sure that metal shelf supports are placed on the inside and the small metal feet are at the bottom.
Page 2 NOTE: These instructions apply to promotional counters with and without vinyl graphics. (Vinyl graphics will be pre-installed onto the PROMXMN counter) If you have any questions regarding our products, please visit us at www.displays2go.com or contact D2G customer service at 844-221-3388.