A&D SW Series Instruction Manual page 29

Item
Serial interface
Response
aCk
Comparator mode
Cp-l
Comparison
conditions
Cp
Key sensitivity
key
Auto-tare
function
at
(See Note)
Auto-tare timing
at-t
(See Note)
Auto-tare for the
initial weight
at-f
(See Note)
Normal/Negative
comparison
Cp-p
(Note: In some countries or areas, "
not available for the Legal for Trade models.)
Parameter
0
No reply except data to commands
 1
Reply to commands
 0
Five-level
1
Three-level
2
Seven-level (portion weighing mode)
 0
Comparator disabled
1
Compares all data
2
Compares all stable data
Compares all data of ≥ +5d or ≤ -5d
3
Compares stable data of ≥ +5d or ≤ -5d
4
Compares data of ≥ +5d
5
Compares stable data of ≥ +5d
6
0
Low
 1
Medium
2
High
 0
Auto-tare function disabled
1
Auto-tare function enabled
0
Immediately after OK and stable
1
0.5 second after OK and stable
 2
1.0 second after OK and stable
3
1.5 seconds after OK and stable
4
2.0 seconds after OK and stable
5
2.5 seconds after OK and stable
6
3.0 seconds after OK and stable
7
4.0 seconds after OK and stable
8
5.0 seconds after OK and stable
9
6.0 seconds after OK and stable
 0
Function disabled
1
Tares the initial (container) weight.
 0
Normal comparison
Negative comparison for take-away
1
check weighing
 Factory setting
d = minimum display in kg, the minimum mass that can be weighed in kg
Even the counting mode uses "d" for judgment.
Description
re5o 5t-b
", " ", "
29
Only when the options,
RS-232C or RS-422/485,
are used.
Sets comparison
conditions
d = minimum display
in kg
Refer to "11. AUTO-
TARE FUNCTION"
Timing to tare
automatically after
the comparison OK
and stable weight.
To be used with "at 1".
Automatic operation
Refer to "11. AUTO-
TARE FUNCTION"
at at-t
", " " and "
at-f
" are