Product Description And Intended Use; Safety Warning + Caution; Legal Disclaimer - Shell newmotion Home Basic Edition 7 Manual

1. INTRODUCTION
1.1 PRODUCT DESCRIPTION &
INTENDED USE
Thank you for choosing a NewMotion Electric Vehicle (EV)
Charge Point.
This charge point is intended to charge the batteries within
EVs compatible with IEC-61851 MODE3 definition and
requirements. Dedicated EV specific plugs will need to be
utilised. No adaptors, conversion adaptors or extension
sets for cables are allowed to be used. EVs and cables
used with this charge point should always be undamaged
and in their original state.

1.2 SAFETY WARNING + CAUTION!

The electrical system must be voltage-free during the
entire installation procedure. Failing to do so can lead to
serious injury or even death. The installation procedure
must be carried out by a trained electrician who works in
accordance with all relevant local laws and regulations.
Do not install in potentially explosive atmospheres and/or
zones with high electromagnetic radiation and/or in flood-
prone areas.
The charge point is connected to the electricity grid and
even if the equipment is switched off, hazardous voltages
may be present at the input terminals. Always switch off
the AC supply before starting any work on the charge point
and/or its installation. Do not carry out any work in rainy
conditions or when the humidity is above 95%. The safety
guidelines are intended to ensure correct installation and
usage. Any failure to comply with the valid safety guidelines
or instructions provided in this manual may result in fire,
electrocution or severe injury.
The charge point is a product in Safety Class I and is
supplied with an earth terminal for protection purposes.
The AC input clamps must be fitted with an uninterruptible
earth for protection purposes. Ensure that the connection
cables are fitted with fuses and circuit breakers. Never
replace a protection component with another type. First
check the full installation to determine if that component
can be used with the existing installation components.
Before you switch on the charge point, check that the
available power source matches the configuration settings
of the product, as described in this manual.
Tripping of the RCD could be caused by an earth fault or a
INSTALLATIEHANDLEIDING – P16
INSTALLATION MANUAL – P16 | P16
defect relay. If, after resetting the RCD, the device cannot
be activated or immediately trips again; please contact your
installer.

1.3 LEGAL DISCLAIMER

This manual is created for you with care.
We however do not guarantee that all information is
complete, accurate and correct.
If you find any unclarities or mistakes in this installation
manual, or if you have any feedback or suggestions in
general about this manual, please inform us at
installationmanualfeedback@newmotion.com and mention
the document version in the subject.
Please check our website
www.newmotion.com/fr_FR/assistance
for the latest version of this manual.
NewMotion strongly advises to have the product installed
by certified professionals. How the product should be
installed and used depends on local circumstances and
local and national regulation, which are not mentioned in
our manual. NewMotion is not responsible for any loss or
damage whatsoever caused – including without limitation,
any indirect, personal or consequential loss or damage –
arising from or in connection with the use of this manual.
Nor does NewMotion accept any liability for any such loss
or damage arising out of your reliance on any information
contained in this manual.
1.4 CHARGE POINT OPERATION
This selected charge point can not be connected to a
Charge Point Operator (CPO) backoffice.
In case of an error or issue, please contact NewMotion
for support.
VERSION 0129NM02INT01
06ANM20INT01