Brother HL-5270DN Network User's Manual page 87
Multi-protocol on-board ethernet print server and wireless (ieee 802.11b/g) ethernet print server
Hide thumbs
Also See for HL-5270DN:
- User manual (152 pages) ,
- Quick setup manual (34 pages) ,
- Technical reference manual (517 pages)
Table of Contents
Advertisement
Wireless installation in ad-hoc mode (HL-5280DW only)
16
Click Next. The settings will be sent to your printer.
The settings will remain unchanged if you click
Cancel.
Note
If you want to manually enter the IP address settings of your printer, click Change IP Address and enter the
necessary IP address settings for your network. After making your selection, click Next and the Wizard will
search for available wireless networks.
17
To communicate with the configured wireless
device, you must configure your PC to use same
wireless settings. Manually change the wireless
settings on your PC to match the printer's wireless
settings shown on this screen. Check Checked and
confirmed, and then click Next.
(The settings shown on this screen are for example
only. Your settings will not be the same.)
You have completed the wireless setup. If you chose to install the drivers in step 6,
go to Installing the printer driver on page 10-9.
10
10 - 8
Advertisement
Table of Contents
Troubleshooting
