Disabling The Apipa Protocol - Brother HL-5270DN Network User's Manual
Multi-protocol on-board ethernet print server and wireless (ieee 802.11b/g) ethernet print server
Hide thumbs
Also See for HL-5270DN:
- User manual (152 pages) ,
- Quick setup manual (34 pages) ,
- Technical reference manual (517 pages)
Table of Contents
Advertisement
Disabling the APIPA protocol
If the APIPA protocol is enabled, the print server will automatically allocate a Link-Local IP address in the
range (169.254.1.0 - 169.254.254.255) when the print server cannot obtain an IP address through the IP
METHOD you have set.
By default, the APIPA protocol is enabled. You can disable the APIPA protocol using the BRAdmin
Professional utility or a web browser. For more information, see Changing the print server settings on page
2-5.
You can also disable the APIPA protocol using the control panel on the top of the printer. Please follow these
steps:
1
Make sure that the front cover is closed and the power cord is plugged in.
2
Turn on the printer and wait until the printer is in the Ready state.
3
Press any of the Menu buttons (+, -, Set or Back) to take the printer off line.
4
Press + or - until NETWORK appears on the LCD display.
5
Press Set to proceed to the next menu level, and then press + or - until APIPA appears.
6
Press Set to proceed to the next menu level, and then press + or - to select OFF. The APIPA protocol
has been set to be disabled.
Note
For more information on APIPA, see Chapter 1 or Chapter 2, or visit http://solutions.brother.com.
Control panel setup
8
8 - 12
Advertisement
Table of Contents
Troubleshooting
