Table of Contents
Advertisement
• Mount the diecast Belt Work Support Table [H] to the Belt Sander Arm Assem-
bly with the included 10mm Socket Head Cap Screw and Washer (FIG 8). Keep
the edge of the Table/Stop approx. 0.063" [1.6mm] from the belt and tighten
screw securely with the an 8mm Hex Key (FIG 9).
The Belt Work Support Table [H] MUST NOT contact the Sanding
Belt. Check for contact with Belt and adjust if necessary.
• As an alternative, mount the steel Alternate Tool Rest [J] to the Belt Sander Arm
Assembly with the included 10mm Socket Head Cap Screw and Washer (FIG
10). Keep the edge of the Tool Rest 0.063" [1.6mm] from the belt and tighten
screw securely with an 8mm Hex Key.
The Alternate Tool Rest [J] MUST NOT contact the Sanding Belt.
Check for contact with Belt and adjust if necessary.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 8
FIG. 9
""""
[1.6mm]
FIG. 10
0.63"
J
7
Advertisement
Table of Contents
