Table of Contents
Advertisement
• Place the Disc Lower Dust Chute [E] over the open bottom section of the
Disc Guard (FIG 5).
NOTE: Slide the rear baffle section into the slots of the Disc Guard casting.
• Secure with the four M4 x 7mm Phillips Head Screws with Captive Washers
(FIG 6).
• Secure the adjustable angle Disc Work Support Table [F] to the Disc Guard
with the two M6 Threaded Knobs and M6 Washers, one on each side allowing
at least 0.063" [1.6mm] space between the edge of the Table and the face of
the Disc (FIG 7).
The Disc Work Support Table [F] MUST NOT contact the Sanding
Disc. Check for contact with Disc and adjust if necessary.
• Slide the steel bar of the Disk Table Miter Gauge Assembly [G] into the groove of
the Disc Work Support Table.
6
FIG. 5
FIG. 6
FIG. 7
F
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
0.63"
[1.6 mm]
Advertisement
Table of Contents
