Table of Contents
Advertisement
ABRASIVE BELT REPLACEMENT
INJURY HAZARD!
Unplug tool before beginning belt replacement or severe personal
injury could result if motor should start during this procedure.
Always use an Eastwood approved 2" x 42" sanding belt to insure
safe operation.
ABRASIVE BELT REMOVAL
1. Remove the Belt Work Support Table or Alternate Tool Rest (FIG 18).
2. Unscrew the two knobs on the plastic Belt Cover and remove the cover (FIG 19).
3. Remove the Lower Guard by unscrewing it with a Phillips head screwdriver
(FIG 20).
4. Release tension on the belt by rotating the Belt Tension Release Arm Clockwise
as viewed from the Left (FIG 21).
NOTE: The Belt Tension is spring loaded and will return to full tension upon
release of the Belt Tension Release Arm
5. Remove the belt from the Rollers (FIG 22).
ABRASIVE BELT INSTALLATION
1. Install the replacement belt onto the Rollers.
2. Rotate the Belt Tension Release Arm Clockwise as viewed from the Left,
reapplying tension to the belt.
3. Reinstall the Lower Guard.
4. Place the Belt cover over the belt and rollers and secure with the two
Threaded Knobs.
5. Replace the Work Support Table or Alternate Tool Rest.
FIG. 21
Rotate to
release tension
10
FIG. 18
FIG. 19
FIG. 20
FIG. 22
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
Advertisement
Table of Contents
