Setting Your Changes As A New Default; Changing Copy Settings; Increasing Copy Speed Or Quality; Enlarging Or Reducing The Image Copied - Brother MFC-820CW User Manual

Changing copy
settings
You can change the copy settings temporarily
for the next copy.
The machine returns to its default settings
after 60 seconds, or if the Mode Timer returns
the machine to Fax mode. (See Setting the
Mode Timer on page 22.)
If you have finished choosing settings, press
Mono Start or Colour Start.
If you want to choose more settings, press a
or b.
Note
You can save some of the settings that
you use most often by setting them as
default. These settings will stay until you
change them again. (See Setting your
changes as a new default on page 71.)
Increasing copy speed or
quality
You can choose the copy quality. The factory
setting is Normal.
Fast
Fast copy speed and lowest amount of ink
used. Use this setting to save time
(documents to be proof read, large
documents or many copies).
Normal
Recommended setting for ordinary
printouts. Good copy quality with
adequate copy speed.
Best
Use this setting to copy precise images
such as photographs. The highest
resolution and slowest speed.
a
Press (Copy).
b
Load your document.
c
Enter the number of copies you want.
d
Press a or b to choose Quality.
12
Press OK.
e
Press a or b to choose Fast, Normal
or Best.
Press OK.
f
If you do not want to change additional
settings, press Mono Start or
Colour Start.
Enlarging or reducing the
image copied
You can choose an enlargement or reduction
ratio.
a
Press
b
Load your document.
c
Enter the number of copies you want.
d
Press a or b to choose
Enlarge/Reduce.
12
Press OK.
e
Do one of the following:
Press a or b to choose the
enlargement or reduction ratio you
want. Press OK.
Press a or b to choose
Custom(25-400%)and then enter
an enlargement or reduction ratio
from 25% to 400%. Press OK.
(For example, press 5 3 to enter
53%.)
50%
69% A4iA5
78% LGLiLTR
83% LGLiA4
93% A4iLTR
97% LTRiA4
100%*
104% EXEiLTR
Making copies
(Copy).
12
12
67