Access Codes And Credit Card Numbers - Brother MFC-820CW User Manual

Chapter 8
c
Press a or b to choose
Set Quick-Dial.
Press OK.
d
Press a or b to choose
Setup Groups.
Press OK.
e
Press a or b to choose the Group you
want to delete.
Press OK.
f
Press a or b to choose Delete.
Press OK.
Press 1 to confirm.
g
Press a or b to choose Complete.
Press OK.
h
Press Stop/Exit.
Deleting a number from a Group
a
Press Menu.
b
Press a or b to choose Fax.
Press OK.
c
Press a or b to choose
Set Quick-Dial.
Press OK.
d
Press a or b to choose
Setup Groups.
Press OK.
e
Press a or b to choose the Group you
want to change.
Press OK.
f
Press a or b to choose the number you
want to delete.
Press OK.
Press 1 to confirm.
g
Press a or b to choose Complete.
Press OK.
h
Press Stop/Exit.
52
Access codes and credit card
numbers
Sometimes you may want to choose from
several long distance carriers when you
make a call. Rates may vary depending on
the time and destination. To take advantage
of low rates, you can store the access codes
or long-distance carriers and credit card
numbers as Speed-Dial numbers. You can
store these long dialling sequences by
dividing them and setting them up as
separate Speed-Dial numbers in any
combination. You can even include manual
dialling using the dial pad. (See Storing
Speed-Dial numbers on page 49.)
For example, you have stored '555' on
Speed-Dial: 03 and '7000' on Speed-Dial: 02.
a
Press Search/Speed Dial.
8
b
Enter 03.
Note
If you stored 2 numbers in one Speed-Dial
location, you will be asked which number
you want to send to.
c
Press a or b to choose Speed-Dial.
Press OK.
d
Enter 02.
e
Press Mono Start or Colour Start.
You will dial '555-7000'.
To temporarily change a number, you can
substitute part of the number with manual
dialling using the dial pad. For example, to
change the number to 555-7001 you could
press Search/Speed Dial, 03 and then press
7001 using the dial pad.
Note
If you must wait for another dial tone or
signal at any point in the dialling
sequence, create a pause in the number
by pressing Redial/Pause. Each key
press adds a 3.5-second delay.
8