Table of Contents
Advertisement
6 - 24
Telephone Style Control Head
1.
Unlatch the Handset from the Cradle as shown in Figure 6-23.
2.
Remove the four screws from the back of the Cradle using a T10 TORX™ screw bit.
3.
Disassemble the Cradle back housing assembly from front housing assembly as shown in
Figure 6-25, on page 6-25.
4.
Disassemble the Cradle top control flex BTB (board to board) connector, RJ50 flex BTB
connector and the wire harness wire to board connector from the Cradle main PCB.
–
Disassembly
Handset
Figure 6-23 Handset Removal
Figure 6-24 Cradle Back Housing Removal
Cradle
ZWG0130214 O
Remove these four screws
to disassemble the Cradle
back housing
Maintenance
ZWG0130215-O
Advertisement
Table of Contents
