Maintenance
5.
Remove the main PCB from the Cradle front housing by unfastenning the two self tapping
screws using a T10 TORX™ screw bit.
6.
Remove the spiral cord retainer from the Cradle front housing.
7.
Unplug the spiral cord cable wire to board connector from the Cradle main PCB. Refer to
Figure 6-27.
Figure 6-25 Cradle Back Housing Assembly Removal
Figure 6-26 Main PCB Removal
Figure 6-27 Spiral Cord Cable Wire Removal
Spiral cord cable
Spiral cord retainer
Main PCB
6 - 25
ZWG0130215-O
ZWG0130215-O
ZWG0130215-O