Setting Volume Amplify
Please carefully read "Choosing the Handset Volume," page 5-5
before you do the following steps:
1
2
3
4
5
Setting the Speaker Volume
You can adjust the volume of the one-way speaker when your
MFC is on
speaker volume level. The default setting is the lowest volume.
You can adjust the speaker volume while you are listening to your
OGM (Outgoing Message) and ICMs (incoming messages).
If you turn the Incoming Recording Monitor to OFF
(
Function
disabled and you will not be able to hear callers leaving messages.
The volume for other operations can still be controlled using
and
5-6
I N I T I A L S E T U P
Function
Press
,
,
1
VOL AMPLIFY:OFF?
SELECT < - - > & SET
Press
or
to select VOL AMPLIFY:OFF? if none of
the users are hearing-impaired and go to Step 4—OR—
if some or all of the users are hearing-impaired, select
VOL AMPLIFY:ON?.
PERMANENT?
SELECT < - - > & SET
Press
or
to select PERMANENT? if all the users are
hearing-impaired—OR—select TEMPORARY? if only some
of the users are hearing-impaired.
Press
Set
.
Press
Stop
to exit.
Hook
. You can turn the speaker off or you can select a
L
H
Press
or
shows the setting you are choosing. Each key press changes
the volume to the next setting. The new setting will remain
until you change it again.
,
,
,
), the Speaker for screening calls will be
1
7
5
H
.
,
.
1
6
to adjust the volume level. The display
L