Switch Access And Login - ZyXEL Communications GS1200 Series User Manual

Check to see that the power adapter is securely connected to the Switch.
1
Check to see the Switch is connected to an appropriate power source, and make sure the power
2
source is on and functioning properly.
Check that the Ethernet cables connection to the devices requiring PoE are connected properly.
3
Make sure you are using the correct type of Ethernet cable. See
4
information about the types of Ethernet cable supported. Contact your local distributor if the problem
persists.
Click System in the navigation panel and check if the total power requested by the PoE-enabled
5
devices exceed the total PoE power budget on the Switch. If it does, reconnect the PoE-enabled
devices in the order that you want the Switch to allocate power to.
See Section 6.8 on page 37
supply.
A loop is detected.
See Section 8.1.1.5 on page 45
To restore a port in a loop state, disconnect it, check the network connections, and reconnect it.
1
You can log into the Web Configurator. Go to System in the Web Configurator to check your port status.
2
Note that you can do this when you enable Loop Prevention (default) in the Port screen. If Loop
Detection is enabled, you cannot log into the Switch.

15.2 Switch Access and Login

I forgot the IP address for the Switch.
The default IP address is 192.168.1.3.
1
If this does not work, you have to reset the device to its factory defaults. See
2
I forgot the password.
The default password is 1234.
1
If this does not work, you have to reset the device to its factory defaults. See
2
Chapter 15 Troubleshooting
for information about the maximum power the Switch and a PoE port can
for more information about PoE.
GS1200 Series User's Guide
68
Section 2.2.1 on page 13
Section 4.4 on page
Section 4.4 on page
for more
22.
22.