For Network Cable Users - Brother DCP-110C Software User's Manual

For Network cable users

1
Insert a SmartMedia
SecureDigital
If more than two media cards are inserted at the same time, the
PhotoCapture Center
first. To have access to another card, you must first take out all
the cards, and then put in the media card you wish to access.
2
Double-click the Network PhotoCapture Centre icon.
3
Your browser software will appear and a list of file names on
your media card will be shown.
Your browser software accesses the media card using FTP and
the network Host Name of the machine. You can open the
software by entering ftp://XXX.XXX.XXX.XXX (Where
XXX.XXX.XXX.XXX is the IP address of your Brother machine).
4
Click the file name you wish to see.
When you take out a media card, do the following to prevent damage
to the media card:
5
Close the browser.
6
Wait until the PhotoCapture button stops blinking before taking
out the media card.
Do NOT unplug the power cord, or remove a SmartMedia
CompactFlash
™
Card from the machine while it is reading the card
(PhotoCapture button flashing). You could lose your data or
damage the card.
If you took out the media card while PhotoCapture button was
flashing, you must immediately restart your PC before putting
the media card back in. If you put in another media card before
the PC is restarted, the data on it may be destroyed.
USING THE PHOTOCAPTURE CENTER
®
, CompactFlash
™
or xD-Picture Card
™
will read only the card that was put in
®
, Memory Stick
®
, Memory Stick
™
into your machine.
®
, SecureDigital
™
FROM YOUR PC 6 - 3
®
,
®
,
™
or xD-Picture