Hanseatic HWM6T214D User Manual page 70

Page EN-32 Troubleshooting table
Problem
During the wash This is not an error. The water is at the bottom of the drum.
cycle, no water
can be seen in the
drum through the
glass panel.
Door won't open af- This is not an error. The opening mechanism contains a safety device
ter the wash cycle that keeps the door closed another 2 minutes or so after the wash cycle
has finished. has finished.
Error code E01 The appliance door is not
closed.
Error code E02 Water level in the appliance is
lower than the heating coil.
Error code E03 Pump is faulty or lint trap is
clogged.
Error code E04 Too much water in the appli-
ance.
Error code E09 Problem with power supply
Malfunction
Possible causes Solutions, tips
Close door properly.
If the problem persists, please con-
tact our Service department (see
page EN-34).
The water pressure, to which the appli-
ance is connected may be too low or
the valve may be closed.
If necessary, open the valve com-
pletely. If the problem persists, please
contact our Service department (see
page EN-34).
Clean lint trap (see page EN-23). If the
problem persists, please contact our
Service department (see page EN-34).
The appliance is automatically pumping
water away. After draining, switch off
the appliance, pull the mains plug out of
the socket and close the valve. Please
contact our Service department (see
page EN-34).
Please contact our Service department
(see page EN-34).