Setting Limits; Set The Limit Positions And Adjust Drive Speed - B&D Smart Pro Installation Instructions Manual

Smart Pro installation instructions

12. Setting Limits

CAUTION! Limit setup is not available when running
on battery backup
Refer to Appendix G for setting limits via a transmitter.
tip
NOTE: SPEED of the opener can not be adjusted
when using this method.

12.1 Set the Limit Positions and adjust drive speed:

When setting the Close limit, ensure the position is when the
door makes first contact with the ground. Alternatively for
the Open limit the position should be at the height of the
garage opening.
NOTE: The drive speed is set to the fastest setting by default.
This may not be suitable for larger doors or for single piece
doors. For tilt doors (J-Type only), please refer to Appendix F
for initial setup.
a. Switch power on, the beeper will sound twice and the
BLUE LED on the CLOSE button
the GEAR LED is lit to indicate that the opener is ready
to set the Close travel limit.
b. Press either the CLOSE
door to the halfway point.
CLOSE limit:
i. Press and hold the CLOSE button
the door, taking note of the speed the door moves.
ii. If the close speed is not suitable, to make a change,
press and hold the CLOSE button and by pressing
the STOP / SET button on the opener it will cycle
through all three speed modes as shown in table.
iii. Once at the desired speed, release the CLOSE
button.
iv. To set the close limit, inch the door by making single
presses of the CLOSE button
position. We recommend the CLOSE limit position
being the first point of contact of the rubber strip
(at the bottom of the door) with the ground.
WARNING! In setting the close limit position,
do not force the door into the floor with
excessive force, as this can interfere with
the ease of operation of the manual release
mechanism.
v. If the door overshoots, press the OPEN button
move the door in the OPEN direction.
vi. When the door is at the desired CLOSE position, press
the STOP / SET button on the opener, the beeper will
sound once and the GREEN LED on the OPEN button
will now flash.
will start to flash and
or OPEN button to move the
to start closing
to the desired
to
Door Opener STATUS
Speed Mode
Fast (Default) On
Medium On
Slow On
OPEN limit:
i. Press and hold the OPEN button
the door, taking note of the speed the door moves.
ii. If the open speed is not suitable, to make a change,
press and hold the OPEN button and by pressing
the STOP / SET button on the opener it will cycle
through all three speed modes as shown in table.
iii. Once at the desired speed, release the OPEN button.
iv. Continue inching the door to the desired position.
v. To set the open limit, inch the door by making
single presses of the OPEN button
position. We recommend the OPEN limit position
being the height of the garage opening.
WARNING! The door will automatically close,
open and close again after the next step.
Ensure that nothing is in the door's path.
vi. If the door overshoots, press the CLOSE button
move the door in the CLOSE direction.
vii. When the door is at the desired OPEN position, press
the STOP / SET button The door will now automatically
close and open to calculate the safety obstruction
settings.
Refer to Appendix B & C for adjustments
tip
to margins.
11
BEEPER &
MAIN LIGHT
3 Beeps & Flashes
2 Beeps & Flashes
1 Beep & Flash
to start opening
to the desired
to