Honeywell Marathon User Manual page 70

LEAP
To use LEAP (without WPA, also called WEP-LEAP), make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set Auth Type as follows:
• If the Cisco/CCX certified AP is configured for open authentication, set Auth Type to Open.
• If the AP is configured to use shared key or passphrase, set Auth Type to Shared.
3. Set WPA to None
4. Set Encryption to WEP
5. Set Authentication to LEAP
See Sign-On vs. Stored Credentials
To use Stored Credentials, scroll down to enter the User Name and Password. No entries are necessary for Sign-On
Credentials as the user will be prompted for the Username and Password when connecting to the network.
Enter the Domain\Username (if the Domain is required), otherwise enter the Username then click Commit.
Ensure the correct Active Profile is selected on the Configuration tab and restart. The Status tab shows the device is
connected.
6 - 20
(page 6-12) for information on entering credentials.