Enable / Disable Parameter Scanning; Imager Parameters - General; Beep After Good Decode - Honeywell Marathon User Manual

Enable / Disable Parameter Scanning

Use this parameter to decide whether bar code reader parameters can be set using the bar codes in this section.
Note: When this parameter is disabled, scan the
parameter scanning.
When disabled, either scan the Enable Parameter Scans bar code or the Set All Defaults bar code to reset the parameter. When
enabled, bar code readers can be configured using the bar codes in this section.
Select a mode by scanning either of the bar codes shown below.
* Enable Parameter Scans
Disable Parameter Scans
Imager Parameters – General
This section contains general imager parameter bar code engine programming codes.

Beep After Good Decode

Scan a bar code below to select whether or not the decoder issues a beep signal after a good decode. If selecting Do Not
Beep After Good Decode, beeper signals are issued during parameter menu scanning and to indicate error conditions.
* Beep After Good Decode (Enable)
Do Not Beep After Good Decode (Disable)
13 - 10
Set All Defaults / Cancel Bar Codes (page 13-9) parameter bar code to enable