Honeywell Marathon User Manual page 61

Ping
The Ping screen is used to ping another device.
IP - Displays the IP address of the Marathon
Use the text box at the upper right to enter the IP address to ping. Information on the selected function is dis-
played in the output box in the center of the screen.
Start (Stop) - Start a continuous ping to the IP address specified in the text box in the upper right of this screen.
Once the button is clicked, the ping begins and the button label changes to Stop. Clicking the button ends the
ping. The ping also ends when any other button on this screen is clicked. The results of the ping are displayed in
the output box. The parameters below are used to configure the ping process:
Parameter Default Description
Delay (ms) 1000 The amount of time, in milliseconds, between each ping after a Start Ping button tap.
Options are: Any number between 0 and 30000 ms.
Timeout (ms) 5000 The amount of time, in milliseconds, that a device will be continuously pinged. The Stop
Ping button can be tapped to end the ping process ahead of the ping timeout.
Options are: Any number between 0 and 30000 ms.
Payload 32 bytes Maximum amount of data to be transmitted on a ping.
Options are: 32 bytes, 64, 128, 256, 512, or 1024 bytes.
Renew IP – Obtain a new IP address through release and renew. All activity is logged in the output box. If a fixed
IP address has been assigned to the radio, this is also noted in the Diagnostic Output box. Note that the current IP
address is displayed above this button.
Reconnect – Use this button to apply (or reapply) the current profile and attempt to associate or authenticate to
the wireless LAN. All activity is logged in the output box.
Utilities
This screen displays the regulatory domain and logging options.
6 - 11