Notis Editing; Set Lengths For Codabar - Honeywell Marathon User Manual

NOTIS Editing

When enabled, the start and stop characters are stripped from a decoded Codabar symbol.
Set this parameter by scanning either of the bar codes shown below.
Enable NOTIS Editing
* Disable NOTIS Editing

Set Lengths for Codabar

Lengths for Codabar may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains. It also includes any start
or stop characters.
See ASCII Character Equivalents
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only Codabar
symbols containing 14 characters, scan the Codabar One Discrete Length bar code and then "1" and "4" bar codes
using Imager Keypad Number Symbols
To begin setting one discrete length, scan this Codabar One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Two Discrete Lengths (Parameter L2)
This option decodes only those codes containing two selected lengths.
For example, when you want to scan only Codabar symbols containing 2 or 14 characters, scan the Codabar Two Dis-
crete Lengths bar code and then "0", "2", "1" and "4" bar codes using
Default = 55.
To begin setting two discrete lengths, scan this Codabar Two Discrete Lengths bar code:
(page 13-86).
(page 13-84). Default = 5.
Imager Keypad Number Symbols (page 13-84).
13 - 63